![]() ![]() ![]() Do not keep the high beams on in city driving. You should only use this setting if you are the only vehicle on the road. This light means the high beams are turned on. Brakes may not work or function properly.Ĭall an auto mechanic for advice and, if needed, tow the vehicle to the closest auto repair shop. It could be due to a low brake fluid level or another issue with the brake system.ĭo not drive with the BRAKE light on. This light indicates a problem with the brake system. Call an auto mechanic for advice or tow the vehicle to a repair shop nearby. Doing so can lead to serious engine problems. If the oil level is low, add engine oil to bring the level between the MIN and MAX marks of the dipstick.ĭo not drive the vehicle or keep the engine running if the oil light stays on. Wait at least 5 minutes, then check the oil level with the engine off. Pull over immediately and shut off the engine. This light means there is alow oil pressure. This light means that the fuel level is low, and you need to add fuel. The windshield washer fluid reservoir has the same symbol on top. Add windshield washer fluid to the reservoir in the engine bay. This light means that the fuel level is low. The battery warning light can be caused by a faulty alternator, serpentine belt problem, defective voltage regulator, and even a bad battery. If the battery light comes on, the vehicle may shut off when driving. The battery warns the driver there is a problem with the charging system. If the TPMS light stays on after adding air, there may be a problem communicating with one of the TPMS sensors, or the TPMS system is faulty. Check the tire pressure and correct it to bring it to the recommended air pressure, as shown on the driver's door frame sticker. This light means there is low tire pressure in one of the tires. Call an auto mechanic for advice or tow the vehicle to an auto repair shop near you. If the engine overheating continues, do not drive. Common problems that cause a Jeep engine to overheat include low coolant level, bad water pump, broken coolant hoses, a faulty thermostat, damaged heater core, etc. Once the engine cools down, check the engine coolant level. Wait at least 30 minutes or more for the engine to cool down fully. This is the warning symbol that indicates that the engine has overheated. To troubleshoot the airbag light on a, you will need to read the fault codes with an airbag scanner. If the airbag light stays, it means the airbags have been disabled and may not deploy in case of an accident. The airbag light turns on when you first turn on the ignition, but after a quick system check, it turns off if all the airbag components function properly. The check engine light or service engine soon light when the on-board diagnostic system detects a problem with either the engine, emission system, or transmission.Ĭommon problems that cause the check engine light to stay on include: loose gas cap, bad oxygen sensor, dirty Mass Air Flow (MAF) sensor,Ī fault code is stored in the Engine Control Unit (ECU) and retrieved with an OBD-II scanner to determine what is wrong with the vehicle. Generic OBD-II scanners may not be able to read airbag scanners. Use an ABS scanner to read the ABS Control Module's fault codes to determine why your Jeep ABS light is on. ![]() While the vehicle can be driven with the anti-lock brake function is disabled, the vehicle may take longer to bring to a complete stop and may skid under hard braking or if it is raining or there is snow on the road. In most cases, the problem is due to a bad ABS wheel speed sensor. This light means that the anti-lock brake system has been disabled.
0 Comments
Leave a Reply. |